Before you start

Apply to clean, dry fabric

Use a flat, firm, heat-safe surface

Apply to one single layer only

Quick steps

Pre-press the garment briefly to remove moisture and wrinkles

Place the patch shiny side up on clean, dry fabric

Cover and press firmly using high heat (no steam) for 20 seconds

Move the iron slowly over the entire patch for 10 seconds to seal all edges

Peel carrier sheet while hot and check edges are fully sealed

Tips for best results

Use a hot, dry iron (cotton or high heat setting on most irons)

Avoid placing over seams, zippers, snaps, or buttons

When using two patches, place on the upper chest near the zipper, one on each side

If using one patch, place near the center of the chest for best visibility

Press firmly with strong, even pressure across the entire patch